Barker Controls, Inc.
Barker Controls, Inc.
Address: 2205 Old Buncombe Road
Greenville, SC 29609
Phone: 800-845-5274
Fax: 864-242-1134
Email: Sales@BarkerControls.com
Website: www.barkercontrols.com
Print Back
Repeat cycle timer with digital setpoints and 4 time ranges... compact 1/8 DIN case

The DA200 series timer is a microprocessor based repeat cycle timer housed in a 1/8 DIN style enclosure. Two 4 digit push-button switches on the front of the unit provide exact setting of the ON and OFF time setpoints. Four time ranges from 99.99 seconds to 99 hours and 99 minutes can be independently programmed for the ON and OFF times. Repeat or Single Cycle operation and ON or OFF time first operation can also be programmed. All programming is done using rocker switches located on the side of the unit.
Unit of Measure

Technical Specs

Brands

 N/A
Eagle Signal

Model

 N/A DA200

Type

 N/A Timer

Operating Voltage/Frequency

 N/A A6 - 120 VAC, 50/60 Hz

Reset Time

 N/A 15 ms

Power on Response

 N/A 35 ms

Transient Protection

 N/A Immune to 2500 volts peak transients up to 50 microseconds in duration

Setting Accuracy

 N/A 0.01% of setting or 35 ms, whichever is larger

Repeat Accuracy

 N/A 0.01% of setting or 35 ms, whichever is larger

Operating Temperature

 N/A 32 to 122 ºF0 to 50 ºC

Static Discharge

 N/A Unit function is unaffected by a constant 3600 volt peak, 60 Hz discharge applied to the front plate at a relative humidity of less than 25%

Vibration

 N/A Unit function is unaffected by 2.5G sinusoidal vibration magnitude in both directions of the perpendicular mounting axes imposed from 20 to 100 Hz

Features

N/A

  • DPDT 5 amp relay output
  • Two LED indicators to show ON and OFF time operation
  • Recessed programming rocker switches with a protective cover to help prevent accidental switch changes
  • 0.01 second setting resolution for fast time cycles and easy to use minute: second and hour: minute time ranges

Additional Information

N/A The DA200 timer can be mounted in three ways for use in most any application. The terminal connections for the unit are 3/16 inch terminals for use with a square base relay socket. This provides a means of mounting the unit within a panel. The DA200 timer can also be mounted through the front of the panel using either an economical fixed bezel kit or a unique plug-in housing which allows easy removal for programming changes and replacement.